Kyocera Mita FS-1128MFP Setup Manual page 13

Panel Setup
1
2
3
4
5
6
7
8
9
10
11
12
1
2
12
IMPORTANT: Check with your network administrator when selecting the network
setting. After all network related settings have been done, turn the machine Off and
On again.
TCP/IP (Enable/Disable TCP/IP)
This selects the settings for TCP/IP.
Press [System Menu/Counter]. The Sys. Menu/Count. screen appears.
Press or to select System.
Enter the user ID and password to log in.
NOTE:
The default settings of user ID and password are both 2800.
Press [OK]. The System screen appears.
Press or to select Network Setting.
Press [OK]. The Network Setting screen appears.
Press or to select TCP/IP Setting.
Press [OK]. The TCP/IP Setting screen appears.
Press or to select TCP/IP.
Press [OK]. The TCP/IP screen appears.
Press or to select whether TCP/IP is enabled.
Press [OK]. The TCP/IP is set and the TCP/IP Setting menu reappears.
IPv4 Settings (TCP/IP IPv4 settings)
This selects the settings for TCP/IP (IPv4).
In the TCP/IP Setting menu, press
Press [OK]. The IPv4 Setting menu screen appears.
The options available in the TCP/IP (IPv4) settings are as follows:
• DHCP (DHCP setting)
• Bonjour (Bonjour setting)
• IP Address (IP address setting)
• Subnet Mask (Subnet mask setting)
• Default Gateway (Gateway setting)
or to select IPv4 Setting.
SETUP GUIDE