Do I Need All Those Pedals; Multiple Controllers; Editing Programs - Kurzweil K2600 Setup Manual

Setup Mode and the Setup Editor
Editing Hints and Suggestions
equal to 64, and <64 means less than 64. >0 means you can use any value thatÕs greater than
zero. x means you can use any value.
Controller
Number
102
103
120
121
122
123
124
125
126
127
Table 7-6

Do I Need All Those Pedals?

ItÕs important to realize that you donÕt have to have an actual pedal plugged into every Pedal
and Switch Pedal jack in order to take advantage of all of them. Entry and exit values can be
assigned to a zone and to a physical controllerÕs destination even if the controller isnÕt there, and
they will behave as if the controller were in fact plugged in. So if you want a speciÞc group of
Controller commands to be sent out whenever you choose a setup, and you know theyÕre not
going to change while youÕre playing, you can assign them as the destinations of physical
controllers that arenÕt in use.

Multiple Controllers

Sometimes youÕll want to assign the same Controller number as the destination of more than
one physical controller. For example, you might want to be able to control modulation depth
both with Wheel 2 and with pressure. The K2600 has no restrictions on assigning multiple
physical controllers to a particular MIDI Controller.

Editing Programs

Remember, except for control-setup parameters, everything you deÞne in a setup affects
programs only while you are in Setup mode. To edit the programs themselves while you are in the
Setup Editor, go to the CH/PRG page and press Edit. This gives you access to the other editors
nested within the Program Editor as well. When you have Þnished editing your program, press
Exit to save it and return to the Setup Editor.
7-48
MIDI
Play/Stop
Record/Stop
All Sound Off
Reset All Controllers
Local Control Off
All Notes Off
Omni mode Off
Omni mode On
Mono mode On (the On value, in some synths,
specifies the number of MIDI channels to
respond to, with one voice on each)
127 Poly mode On
Little-used MIDI Control Sources
MIDI Controller On Value Off Value
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>=64 <64
>0 x