The Continuous Control Pedal (Cpedal) Page; The Ribbon Page - Kurzweil K2600 Setup Manual

The Continuous Control Pedal (CPEDAL) Page

If you look at the back of the instrument, you will see that there are jacks for plugging in two CC
(Continuous Control) pedals. There is also a jack labeled Breath Controller. This jack is wired in
parallel with CC Pedal 2; in other words, you can send MIDI 02 Breath (or any other MIDI or
global Controller) with both CC Pedal 2 and an breath controller.
EditSetup:CPEDAL||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
CPed1:|Foot|||||100%|0|||Lin||None|None|
CPed2:|Breath|||100%|0|||Lin||None|None|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
Parameter
Destination (CPed1)
Destination (CPed2)
Scale
Add
Curve
Entry Value
Exit Value

The RIBBON Page

The RIBBON page lets you deÞne controller assignments for the K2600Õs two ribbon controllers.
Each ribbon senses movement when you press on it and move your Þnger left or right; this
creates numerous possibilities for controlling pitch, volume, panning, crossfades between zones,
or any other uses you might imagine.
The Large Ribbon can be used as a single long controller, or it can be divided into three separate
sections, each with its own controller assignments (this is done on the RIBCFG page). The two
small arrows above the strip indicate the boundaries of the three sections. The large arrow above
the ribbon points to the center of the ribbon, for when the ribbon is conÞgured in one section.
The Small Ribbon, located below the wheels, is both pressure- and motion-sensitive, so it will
respond to both Þnger position and pressure.
To modify other ribbon parameters, go to the RIBCFG page, which is described on page 7-44.
The Continuous Control Pedal (CPEDAL) Page
Range of Values
MIDI Control Source list
MIDI Control Source list
±300%
-128 to +127
Curve list (see text)
None, 0–127
None, 0–127
Setup Mode and the Setup Editor
Default
Foot
Breath
100%
0
Lin
None
None
7-29