Kurzweil K2600 Setup Manual page 4

Setup Mode and the Setup Editor
Setup Mode
Control Setup–Setup
Editor Page, Zone 1
CH/PROG
KEY/VEL
PAN/VOL
BEND
COMMON
ARPEG
RIBCFG
Continuous Controller
assignment pages
(SLIDER, SLID/2,
CPEDAL, RIBBON,
WHEEL, PRESS)
Switch Controller
assignment pages
(FOOTSW, SWITCH)
KDFX, FXMOD2,
FXMOD3, FXMOD4,
FXLFO, FXASR, FXFUN
Table 7-1
In summary, physical controller destinations, their curves and states, and the Arpeggiator
parameters all deÞne controller assignments for programs in Program mode. The other
parameters have no effect; this keeps Program mode relatively simple. Program mode lets you
change values for transposition, MIDI channels, and programs independently of the control
setup.
Once you save changes to the control setup, those changes will affect all programs when you are
in Program mode. For example, programming the Large Ribbon in the control setup to have
three sections will mean that in every program in Program mode, you will have a three-section
Large Ribbon.
You may want to program several different control setups, and switch among them for different
applications. Suppose, for example, that youÕre recording a song, but you donÕt want to record
aftertouch. You can create a setup with pressure turned off in Zone 1 (on the PRESS page in the
Setup Editor, set the value of the Press parameter to Off for Zone 1). Now whenever you want to
record without aftertouch, just select this setup as the control setup.
7-4
Parameters Affecting
Program Mode
ZoneArpeg, Destination,
MIDIBankMode
VelScale, VelOffset,
VelCurve
None
All
Sync
All
All
Dest, Scale, Add, Curv
SwType, Dest, On, Off
None
Control Setup Parameters Affecting Program Mode
Parameters Not Affecting
Program Mode
LocalPrg, Out, Channel, MIDIBank,
MIDIProg, Status, EntryProgChg
LoKey/HiKey, Transpose, NoteMap,
LoVel/HiVel
Ent and Exit
Ent and Exit