Continuous Controllers - Kurzweil K2600 Setup Manual

Setup Mode and the Setup Editor
Controllers
To get an idea of the expressive capabilities of Setup mode, explore the factory setups that come
with the K2600.
The K2600Õs physical controllers include the following:
¥ The eight sliders (A, B, C, D, E, F, G, H) in the Assignable Controllers section
¥ The two Continuous Control Pedal jacks (CCPedal 1 and CC Pedal 2)
¥ The Large Ribbon, which you can deÞne as a one- or three-section controller
¥ The Small Ribbon, which responds to both Þnger position and pressure
¥ The Pitch Wheel
¥ The Modulation Wheel (Mod Wheel)
¥ Keyboard aftertouch, or Mono Pressure (MPress)
¥ The Breath Controller jack (which is connected to Continuous Controller Pedal 2)
¥ The two Panel Switches, located above the Pitch and Mod Wheels
¥ The four Footswitch pedal jacks (1, 2, 3, and 4)
The following tables and illustration provide an overview of the physical controllers and their
parameters.

Continuous Controllers

Sliders A, B, C, D, E, F, G, H
CPedals 1 & 2 / Breath
Small Ribbon and Large
Ribbon
Pitch Wheel and Mod Wheel
MPressure
Table 7-3
7-22
Physical Controller
Continuous Controllers
Setup Editor
Page
Destination: MIDI Control Source list
Scale: -300% to 300%
Add: -128 to 127
Curve: Linear, Expand, Compress, Crossfade,
SLID, SLID/2
Bump, Reverse Linear, Reverse Expand, Reverse
Compress, Reverse Crossfade, Reverse Bump
Entry Value: None, 0 - 127
Exit Value: None, 0 - 127
CPEDAL (same as Sliders)
RIBBON (same as Sliders)
WHEEL (same as Sliders)
PRESS (same as Sliders)
Parameter:Values