Options; Pedals; Usb Storage Device - Kurzweil PC3LE Musician's Manual

Introduction

Options

Options

Pedals

The PC3LE has two stereo jacks (labeled SW1 & SW2) for switch pedals (assignable to on/off
functions, these pedals control sustain and sostenuto by default.) The PC3LE also has one jack
for a continuous pedal (assignable to continuous controller functions, this pedal controls
volume by default.) Ask your Kurzweil dealer about the following optional pedals:
FS‐1
KFP‐1
KFP‐2M
CC‐1

USB Storage Device

You can plug a USB mass storage device such as a "thumb drive" into the PC3LE for backing up,
archiving, sharing your work, and updating your software. Any size USB mass storage device
will work, though thumb drives are recommended for their portability, durability, and low
price.
Note: Most USB thumb drives are compatible with the PC3LE, but some older USB thumb drives and
larger USB bus powered drives will not work with the PC3LE if they require more than 500 mA of
current. When attempting to use an incompatible USB device, the PC3LE will display the message "USB
device requires too much power". Power requirement specifications for thumb drives are not always made
clearly available by the manufacturer, but a newly purchased thumb drive will most likely be compatible.
If possible, check the power requirement specifications of your USB device before purchase.
1-4
Standard box‐shaped switch pedal
Single piano‐style switch pedal
Double piano‐style switch pedal unit
Continuous pedal