Output Assignment (Out) - Kurzweil K2600 Setup Manual

Setup Mode and the Setup Editor
The Channel/Program (CH/PROG) Page
All zones active.
Program
Press Mute 1, and the current zone
is muted.
Program
Current zone active; one or more other
zones muted.
Program
All zones active.
Program
Figure 7-1
The K2600 keyboardÕs mode-selection buttons also light as shown above. However, buttons 1Ð8
are more convenient for muting, unmuting, and soloing zones.

Output Assignment (Out)

This determines the signal routing for each zone in the setupÑnot the Þnal audio output, but
the KDFX input to which the zoneÕs signal gets sent. You can route the zone to KDFX A
through D, or you can use a value of Prog, which uses the output assignments of the program
thatÕs assigned to that zone.
7-10
Setups Containing 3 or Fewer Zones
S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
Setups Containing 4 or More Zones
S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
Soloing Zones With the K2600R
Press Mute 1, Mute 2, or Mute 3 to
mute each zone.
Program S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
Press Mute 2 or Mute 3,
and the current zone is soloed; press
Chan/Bank buttons to solo each zone.
Program S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
One or more zones muted, including
current zone.
Program S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec
All zones muted.
Program S etup Q Access
Mute 1 Mute 2 Mute 3
Zoom - Zoom + Samp/Sec