Accessing The Setup Wizard After Installation - NETGEAR MBRN3000 User Manual

Mobile Broadband Wireless-N Router MBRN3000 User Manual
2. Enter adminC for the router user name and your password (or the default, password
information about how to change the password, see
page 3-2.
Note: The router user name and password are not the same as any other user name or
password you might use to log in to your Internet connection.
3. If the router has never been configured, the Smart Wizard screen displays. After the router has
been configured, the Firmware Upgrade assistant will appear.
• Checking for Firmware Updates screen. After initial configuration, this screen displays
unless you previously cleared the Check for Updated Firmware Upon Log-in check
box.
Figure 1-2
• Router Status screen. The Router Status screen displays if the router has not been
configured yet or has been reset to its factory default settings. See
Router Status Information" on page
4. You can use different methods to configure your router.
• Select Setup Wizard from the router menu to set up your Internet connection and wireless
network configuration. See
• You can manually configure the router settings. See
Settings" on page

Accessing the Setup Wizard after Installation

1. Log in to the router as described in the previous section,
page 1-5.
1-6
4-4.
"Accessing the Setup Wizard after Installation" on page
1-7.
v1.0, October 2009
"Changing the Built-In Password" on
"Viewing Modem
"Manually Configuring Your Internet
"Logging In to Your Router" on
Configuring Your Router to the Internet
For
).
1-6.