Metra Electronics 95-7298B Installation Instructions Manual page 5

Climate Display Installation
1. Remove (4) Phillips screws securing the
radio/hazard assembly to the climate/
radio control panel, then unclip and
remove the assembly.
(Figure C, heavier arrows)
2. Remove (9) Phillips screws securing
the back cover to the radio/hazard
assembly, then remove the cover.
(Figure C)
3. Using a pick tool, gently release (4)
clips holding the hazard switch to the
assembly, then remove the switch.
(Figure D)
Continued on the next page
KIT PREPARATION
(Figure C)
(CONT.)
(Figure D)
REV. 9/14/2022 INST95-7298B
5