Metra Electronics 95-7298B Installation Instructions Manual page 15

Dual assignment instructions (long button press)
The ASWC-1 has the capability to assign (2) functions to a single button, except "Volume-Up" and
"Volume-Down". Follow the steps below to program the button(s) to the desired setting.
Note: "Seek-Up" and "Seek-Down" come pre-programmed as "Preset-Up" and "Preset-Down"
for a long button press.
1. Turn the key to ignition but do not start the vehicle.
2. Press and hold the desired steering wheel control button for (10) seconds, or until the L.E.D.
flashes rapidly. At this point release the button; the L.E.D. will then go solid.
3. Press and release the "Volume-Up" button the number of times corresponding to the new
button number selected. Refer to the Dual Assignment Legend. The L.E.D. will flash rapidly
while the "Volume-Up" button is being pressed, and then go back to a solid L.E.D. once
released. Proceed to the next step once the "Volume-Up" button has been pressed the
desired number of times.
Caution: If more than (10) seconds elapses between pressing the "Volume-Up" button, this
procedure will abort, and the L.E.D. will go out.
4. Press the desired button to store it to memory. The L.E.D. will now go out indicating the new
information has been stored to memory.
Note: These steps must be repeated for each button desired to assign a dual assignment feature
to. To reset a button back to its default state, repeat Step 1, then press the "Volume-Down"
button. The L.E.D. will go out, and the dual assignment feature for that button will be erased.
ASWC-1 STEERING WHEEL CONTROL SETTINGS
Dual Assignment Legend
Function # Function
1 Not allowed
2 Not allowed
3 Seek-Up/Next
4 Seek-Down/Prev
5 Mode/Source
6 ATT/Mute
7 Preset-Up
8 Preset-Down
9 Power
* Not applicable in this application
(CONT.)
Function # Function
10 Band
11 Play/Enter
12 PTT (Push to Talk)
13 On-Hook
14 Off-Hook
15 Fan-Up *
16 Fan-Down *
17 Temp-Up *
18 Temp-Down *
REV. 9/14/2022 INST95-7298B
15