Konica Minolta Magicolor 7300 User Manual page 204

Symptom
You hear
unusual
noises.
Media is
wrinkled.
196
Cause
The printer is not on a
level enough surface.
The media tray is not
installed correctly.
There is a foreign
object stuck inside
the printer.
The media is moist
from humidity or
having water spilled
on the paper supply.
Unsupported media
is being used.
Solution
Put the printer on a flat, hard, level
surface (not exceeding ±1° slant at any
point around the machine).
Remove the media tray that you are
printing from and reinsert it completely
into the printer.
Turn off the printer and remove the
object. If you cannot remove it, contact
Technical Support. See the Service &
Support Guide for a list of sources of
service and support for many areas of
the world. For the most up-to-date
information globally, check
www.konicaminolta.net/printer/.
Remove the moist media and replace it
with new, dry media.
Use KONICA MINOLTA-approved
media. See "Media Types" on page 15.
Check printer.konicaminolta.net/
support (click on "Answer Base") for
currently approved media.
Solving Problems