ESC.K
FORMAT
[ESC].K
EXPLANATION
This command executes one vector of the currently-active DXY-GL or RD-GL I com
mand, aborts all other subsequent commands and clears the data buffer.
ESC.R
FORMAT
[ESC].R
EXPLANATION
This command sets all the settings of the device control commands to their default
values.
When ESC.R is executed, the results are the same as executing the device control com
mands below.
[ESC].J
[ESC]. M:
[ESC] .N:
[ESC] .H:
[ESC],I
[ESC].@:
5.4.4
Monitor Mode Commands
The DXY-1000 series is capable of outputting data sent from the computer to a terminal
and so forth. Cables used for this purpose should be wired as shown in " 5.2.2 Y-Connec-
tion" in Chapter 5, Fig. 5-4 with the DIP Switch 2-(4) turned ON (Y-DROP).
ESC.Y
ESC.(
FORMAT
[ESC] .Y or [ESC].(
©EXPLANATION
After the power is turned ON in the Y-DROP mode (DIP Switch 2-(4) is ON), the DXY-
1000 series ignores all data until is receives this command. The ignored data are output
through pin No. 14 of the RS-232C connector to the terminal.
Abort command
Reset device control
Plotter ON
5-23