Exchange Procedure - Konica Minolta Magicolor 2430 DL Manual

Introduction
Thank you for contacting a technical support representative to obtain
information about returning your magicolor 2430 DL/magicolor 2450 for
warranty exchange. Follow these instructions very carefully.
If you need additional assistance, refer to the General Information Guide
(included with the original printer) or printer.konicaminolta.com for worldwide
sources of service and support.
Attention
Failure to follow these instructions could result in voiding your
warranty.

Exchange Procedure

Each of these steps is explained in detail in this guide.
1
Unpack the exchange printer.
2
Prepare the original printer—turn it off, unplug the
power cord, and remove the interface cables and dust
cover.
3
Move the consumables (the four toner cartridges, the
drum cartridge, and the transfer belt unit) from the origi-
nal printer to the exchange printer.
4
Finish setting up the exchange printer—plug it in, attach
the interface cables, turn it on, install the dust cover, and
fill the tray with media.
5
Repack the original printer, and call the shipper for
pickup.
Introduction
See page 2.
See page 4.
See page 6.
See page 12.
See page 14.
1