ECS P6VXM2 Manual page 64

MODEM Use IRQ
If you want an incoming call on a modem to automatically resume the
system from a power-saving mode, use this item to specify the interrupt
request line (IRQ) that is used by the modem. You might have to con-
nect the fax/modem to the mainboard Wake On Modem connector for
this feature to work.
Soft-Off by PWRBTN
Under ACPI (Advanced Configuration and Power management Inter-
face) you can create a software power down. In a software power down,
the system can be resumed by Wake Up Alarms. This item lets you in-
stall a software power down that is controlled by the normal power
button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec.
then you have to hold the power button down for four seconds to cause
a software power down.
AC Resume Function
This sets the power state after a shutdown due to an unexpected inter-
rupt of AC power.
Wake Up Events
This item opens a submenu that enables you to set events that will re-
sume the system from a power saving mode. Select Wake Up Events
and press Enter to display the following menu:
CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
USB Resume from S3/S4/S5
VGA
LPT & COM
HDD & FDD
PCI Master
PowerOn by PCI Card
Wake Up On LAN/Ring
RTC Alarm Resume
x Date (of Month)
x Resume Time (hh:mm:ss)
Primary INTR
IRQs Activity Monitoring
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
Default: Instant-Off
Default: Always Off
Wake Up Events
Disabled
OFF
LPT/COM
ON
OFF
Enabled
Disabled
Disabled
0
0 0 0
ON
Press Enter
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
58
Default: 3
Item Help
Menu Level
F1:General Help