ECS P6VXM2 Manual page 47

CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
IDE HDD Auto-Detection
IDE Primary Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted if you want the Setup Utility
to automatically detect and configure a hard disk drive on the IDE
channel.
Note: If you are setting up a new hard disk drive that supports
LBA mode, more than one line will appear in the parameter box.
Choose the line that lists LBA for an LBA drive.
IDE Primary/Secondary Master/Slave
If you leave this item at Auto, the system will automatically detect and
configure any IDE devices it finds. If it fails to find a hard disk, change
the value to Manual and then manually configure the drive by entering
the characteristics of the drive in the items below (Capacity, Cylinder,
Head, Precomp, etc.) Refer to your drive's documentation or look on
the drive if you need to obtain this information. If no device is installed,
change the value to None.
Note: Before attempting to configure a hard disk drive, make sure
you have the configuration information supplied by the manufac-
turer of your hard drive. Incorrect settings can result in your
system not recognizing the installed hard disk.
IDE Primary Master
Press Enter
Auto
Menu Level
Auto
To auto-detect the
8448 MB
HDD's size, head . . . on
16368
this channel
16
0
16367
63
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
41
Item Help
F1:General Help