Setting Limit Mode And Reference Value; Setting Limit Mode - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Setting Limit Mode and Reference Value

Setting limit mode

This procedure determines the format used to set the upper and lower limits of the
measurement values for BIN sorting.
Step 1. Click with the mouse in the BIN limit setting mode cell in the sorting condition to be set
(one of conditions 1 to 4).
Step 2. Click the down arrow () at the right edge of the cell.
Step 3. Click the desired limit mode from the drop-down list box to select it (Figure 8-3).
Limit mode
ABS
PCNT
DEV
Figure 8-7 Selection of limit mode for sorting condition 1
Chapter 8
Sorting According to Measurement Results
Setting Limit Mode and Reference Value
Definition
Absolute mode. The limits of each BIN
are set as absolute values. If you select
this mode, you do not need to set the
reference value (nominal).
Percentage mode. The limit value of each
BIN is set as a percentage of the reference
value.
Deviation mode. The limit value of each
BIN is set as a difference with respect to
the reference value. Use the same unit as
that of the set measurement parameter.
181