Cisco Catalyst IR8140 Heavy Duty Series Hardware Installation Manual page 88

Connecting an Ethernet Cable to the Router
1
2
3
Step 8 Thread the adapter base into the Ethernet port and tighten with 3-4 ft-lbs of torque.
Step 9
Insert "keyed" grommet into the adapter base.
Step 10 Install the split gasket around the cable, and then insert the gasket into the compression ring.
Step 11
Tighten the compression cap (1 in the following figure) until the grommet and gasket compress on to the cable and
provides seal and cable stress relief. Use an adjustable or open-end wrench to tighten to 2.7 to 3.2 lb.ft (3.66 to 4.34
Nm).
Cisco Catalyst IR8140 Heavy Duty Series Router Hardware Installation Guide
72
RJ-45 cable connector
Adapter base
Grommet
4 Split gasket
5 Compression cap
Connecting the Router