Cisco Catalyst IR8140 Heavy Duty Series Hardware Installation Manual page 39

Installation Safety and Site Preparation
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
The FCC, with its action in ET Docket 9608, has adopted a safety standard for human exposure to RF
electromagnetic energy emitted by FCC-certified equipment. When used with approved Cisco antennas, Cisco
products meet the uncontrolled environmental limits found in OET 65 Subpart C and ANSI C95.1 2019.
Proper operation of this radio device according to the instructions in this publication results in user exposure
substantially below the FCC recommended limits.
The antenna(s) used for this device may be located with or operating in conjunction with the following devices
only:
1. Two or more modular transmitters with FCC ID: N7NEM7455, only one (1) of which may transmit
simultaneously with other transmitters types.
2. Two or more modular transmitters with FCC ID: N7NWP7610, only one (1) of which may transmit
simultaneously with all other transmitters types.
3. Two or more modular transmitters with FCC ID: RI7LM960, only one (1) of which may transmit
simultaneously with other transmitters types.
4. Two or more modular transmitters with FCC ID: LDK-CGMOFDM, only one (1) of which may transmit
simultaneously with other transmitters types.
To ensure RF exposure compliance, installers must be provided with antenna installation and transmitter
operating conditions described in this document and in the antenna installation documentation.
FCC Class A warnings
The following information is for FCC compliance of Class A devices:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case users will be required to correct the interference at their own expense.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1. 1. This device may not cause interference.
2. 2. This device must accept any interference, including interference that may cause undesired operation
of the device.
Cisco Catalyst IR8140 Heavy Duty Series Router Hardware Installation Guide
FCC Safety Compliance Statements
23