Reset Button - Cisco Catalyst IR8140 Heavy Duty Series Hardware Installation Manual

Table of Contents

Reset Button

Step 1

Verify that the unit is grounded as described in

Step 2

Turn off power to the AC power source at the designated circuits.

Step 3

Align the notch in the AC power cable connector with the key in the router AC power connector, then push the cable

connector into the router connector. When the cable connector is fully seated, rotate the cable connector ring clockwise

until hand-tight.

Figure 34: Router AC Connector and AC Connector Key

AC power connector

Step 4

Confirm the router antennas are connected to the router before you apply power to the router.

Step 5

Connect the other end of the AC power cable to the power source, using the instructions that came with the connecting

device.

Step 6

Turn on AC power at the designated circuits. The router powers on and boots the software image.

There is a reset button on the CPU module. See the following figure for reset button location.

Figure 35: CPU Module Components

Cisco Catalyst IR8140 Heavy Duty Series Router Hardware Installation Guide

Grounding

Instructions.

Connecting the Router

AC connector key

Table of Contents