Calibration Interval; Condensed Status Setup; Condensed Status Mode - Siemens Sitrans Probe LU Instruction Manual

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual

5.4. Calibration Interval

5.4.1. Time Elapsed Since Last Calibration
5.4.2. Maintenance Required Limit
5.4.3. Maintenance Demanded Limit
5.4.4. Maintenance Alert Activation
5.4.5. Total Calibration Interval
5.4.6. Units
5.4.7. Maintenance Status
5.4.8. Acknowledge Status
5.4.9. Acknowledge

6. Condensed Status Setup

6.1. Condensed Status M ode
Event Index
Event Status
Event Diagnosis
6.1.1. Loss of Echo S0 (Status; Diagnosis)
6.1.2. Cable Fault S1 (Status; Diagnosis)
6.1.3. No Tech Power S2 (Status; Diagnosis)
6.1.4. Device Lifetime Maintenance Required Limit S3 (Status; Diagnosis)
6.1.5. Device Lifetime Maintenance Demanded Limit S4 (Status; Diagnosis)
6.1.7. Sensor Lifetime Maintenance Required Limit S6 (Status; Diagnosis)
6.1.8. Sensor Lifetime Maintenance Demanded Limit S7 (Status; Diagnosis)
6.1.9. Device Service Maintenance Required Limit S8 (Status; Diagnosis)
6.1.10. Device Service Maintenance Demanded Limit S9 (Status; Diagnosis)
6.1.11. LTB Scale S10 (Status; Diagnosis)
6.1.12. Internal Temp Sensor S11 (Status; Diagnosis)
6.1.13. Internal Temp High S12 (Status; Diagnosis)
6.1.15. AIFB1 PV Range S14 (Status; Diagnosis)
6.1.16. AIFB2 PV Range S15 (Status; Diagnosis)
6.1.18. Calibration Schedule Maintenance Required Limit S17 (Status; Diagnosis)
6.1.19. Calibration Schedule Maintenance Demanded Limit S18 (Status; Diagnosis)
6.1.29. Memory RAM S28 (Status; Diagnosis)
6.1.30. Memory EEPROM S29 (Status; Diagnosis)
6.1.31. Memory EEPROM Flags S30 (Status; Diagnosis)
6.1.32. Memory Flash S31 (Status; Diagnosis)
6.1.33. Ident Violation S32 (Status; Diagnosis)
6.1.34. Internal Temperature Calibration S33 (Status; Diagnosis)
7ML19985JB02 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
Doc Id: VM11
Active Date: 15/12/2006
(continued on next page)
Page 101