Table of Contents
Advertisement
Service Information
Contact an authorized Fluke Calibration Service Center if the Product needs calibration or repair during
the warranty period. Please have Product information such as the purchase date and serial number
ready when you schedule a repair.
Specifications
Complete specifications are located in the printed Safety Information document that came with the
Product.
Quick Start
The subsequent sections detail how to get the Product ready for use.
Unpack the Product
Unpack the Product carefully and inspect it for any damage that may have occurred during shipment. If
there is shipping damage, notify the carrier immediately.
Verify that these components are present:
•
9009 Industrial Dual-Block Calibrator
•
9009 Safety Information
•
Two 3102-3 4.76 mm (3/16 in) and two 3102-4 6.35 mm (1/4 in) Inserts
•
Power Cord
•
Report of Calibration with calibration label
•
RS-232 Cable
•
Insert Removal Tool
Set Up
To set up the Product:
1. Place the Product on a flat surface with at least 457 mm (18 in) of clearance above the instrument.
2. Plug the power cord into a grounded mains outlet.
Make sure that the nominal voltage corresponds to that indicated on the Product, see the
specifications in the printed Safety Information.
3. Check that the well is clear of any foreign objects, dirt, and grit and carefully insert the probe
sleeves into the wells.
Do not drop the sleeve in the well. Probe sleeve holes should be of the smallest diameter possible
while still allowing the probe to slide in and out easily. Sleeves with various hole sizes are available
from Fluke Calibration. Insert the sleeve with the small tong hole positioned upward.
4. Power on the Product.
Toggle the switch on the power entry module (PEM). The fan blows air through the Product and the
display illuminates after 3 seconds. The calibrator heats or cools to the previously programmed
temperature set-point. The front panel displays indicate the actual calibrator temperature. After a
brief self test, the Product begins normal operation.
Industrial Dual-Block Calibrator
Service Information
3
Advertisement
Table of Contents
