Table of Contents
Advertisement
Introduction
The Fluke Calibration 9009 Industrial Dual-Block Calibrator (the Product, calibrator, or instrument) is a
portable instrument/bench-top temperature calibrator. Use the Product to calibrate thermocouple and
RTD temperature probes. The Product is small enough to use in the field, and accurate enough to use
in the lab. With an ambient temperature of -15 °C (5 °F), calibrate over a range of -15 °C to 350 °C
(5 °F to 622 °F). The resolution of the display is 0.1 degrees.
The Product features:
•
Two independently controlled temperature blocks
•
Rapid heating and cooling
•
Interchangeable multiple hole probe sleeves
•
Convenient integrated carrying case
•
RS-232 interface
Built in programmable features include applicable to both the hot and cold blocks):
•
Temperature scan rate control
•
Eight Set-point memory
Adjustable readout in °C or °F
•
The temperature of each well is accurately controlled by a precision controller. The controller uses a
precision platinum RTD as a sensor and controls the well temperature with a solid-state relay (triac)
driven heater.
The LED front panel (display) continuously shows the current well temperature. Set the temperature
with the control keys to any desired temperature within the specified range. Multiple fault protection
devices ensure user and Product safety and protection.
When one of the temperature blocks is accessed through the front panel, the other
temperature block control panel is not accessible. Always push EXIT to exit the control panel in
use.
Note
1
Advertisement
Table of Contents
