Table of Contents
Advertisement
Operation
1. Pull out regulator knob and turn fully counter-clock-
wise. Open relief valve on cup lid (counter-clock-
wise).
2. Open lid and fill cup with desired sprayable material.
3. Close lid and seal by turning clockwise, hand-tight.
4. Close relief valve on cup lid hand-tight, turning
clockwise.
5. Set regulator (not supplied) to desired PSI (this is
your atomizing air).
6. Slowly turn cup regulator knob clockwise while
pulling gun trigger fully back to start material flow.
Continue turning regulator knob clockwise until
desired material flow is achieved. Push in regulator
knob to lock.
309925B
Maximum cup pressure is 50 psi (345 kPa, 3.4
bar).
7. To decrease paint flow, pull out regulator knob and
turn counter-clockwise to lower cup pressure.
8. Open the relief valve to bleed off excess pressure.
9. Reseal relief valve. Repeat step 6. The cup lid has a
check valve that prevents the cup from losing
pressure until the relief valve is opened.
•
Atomizing air for the spray gun can be adjusted
with an air adjusting valve installed on the
spray gun.
•
To achieve desired cup pressure always start
at a lower pressure and increase to the desired
setting.
Operation
5
Advertisement
Table of Contents
