Curtis Airpot G3 D500 User Manual page 25

4.1.3 Programming
See the fi rst page of the programming guide for
instructions on accessing each individual menu item.
some menues save and exit automatically when a
parameter is updated. Other menus exit to the previous
menu when a parameter is saved. To exit, press
EXIT appears on the display, then press
The following options are available:
Brew by Volume - adjusts the amount of coffee
brewed by time rather than by volume (the factory
default is 2.2L). With an empty airpot in place, press
the appropriate BREW button. When the desired
volume is reached, press the same BREW button again
to stop the brew cycle and set the volume.
Brew by Time - adjusts the amount of coffee brewed
by time rather than by volume (the factory default is
3min - 0sec). Once accessed, press
number of minutes is fl ashing. Then press
to change the number value. Press
number of seconds is fl ashing. Then press
to change the number value. Press
fl ashing, then, press
Temperature - sets the brewing temperature of the
water tank (the factory default is 93°C). The range is
77°C to 97°C. Once accessed, press
the desired temperature. Then press
Energy Save Mode - saves energy during periods
when the brewer is not in use (the factory default is
OFF). When set to ON, the brewer automatically shuts
off two hours after the last brew cycle. Press the ON/
OFF button to return to normal operation. When set to
ON 60°C, the brewer shuts off two hours after the last
brew cycle, but the water tank temperature remains
60°C. Use the ON 60°C setting to reach brewing
temperature faster after periods of non-use.
User manual Curtis G3 Airpot Brewer
.
or
or
or
to exit.
or
to set and exit.
Software | Control module
until
until the
repeatedly
until the
epeatedly
until ‚ex' is
to choose
25