Software Upgrade - Strong SRT 3030 User Manual

7.6.1 Software Upgrade

If a software update for your receiver model should become available it will be published on our official website, there
download the required update from the support page. Unzip the file on your computer and copy the software file to
the root folder of your USB storage device. This may be a USB Pen drive.
NOTE
At Upgrade Type is also the Dump function available. Write settings and channel lists to the
USB device before upgrading software. See below at Dump.
For software upgrade at the receiver:
Connect your USB device containing the new software to the USB port of the unit.
Go to the Software Upgrade menu.
There, press OK to enter to the USB Upgrade sub menu.
At Upgrade Type select USB Upgrade (default)
At Section select All (default)
At File Path press OK.
A popup screen will show, if applicable, select the partition (USB (C:) is default) where the file is stored. The root folder
is now shown in the popup, and then select the correct update file. Then press OK, the file will be selected for upgrade.
Go to {Start} and press OK. A progress banner will now be displayed, running up to full Yellow. The receiver will reboot
and start with the Installation Guide menu. Then re-install our receiver.
WARNING Do not download and upgrade with software that was not published on our official website.
WARNING
NEVER power off the receiver or remove the USB device during the USB Upgrade process.
Doing so might cause irreparable damage to your receiver and will void your warranty.
Dump: Other options in the Software Upgrade menu at Upgrade Type is the Dump function.
With this function you can back-up the settings and channel list(s) you have created before, to quickly re-install those
after for example a software upgrade.
At Upgrade Type select Dump.
At File Path press OK.
Select the root folder of our USB device.
Go to Start and press OK. A progress banner will now be displayed, running up to full Yellow. A file with the name
dump_all.bin will be created on your USB device. Press OK and EXIT to continue.
NOTE If needed, you may this rename this file on a PC, for example adding date and time,
to distinguish for future use.
Update Type User: With this function you can re-install a previously made back-up file with Dump. The settings and
channel list(s) you have created before, can quickly be re-installed after for example a software upgrade.
At Upgrade Type select USB Update.
At Section select User
At File Path press OK.
A popup screen will show, if applicable, select the partition (USB (C:) is default) where the file is stored. The root folder
is now shown in the popup, and then select the correct update file. (Default name dump_all.bin). Then press OK, the
file will be selected for upgrade. Go to Start and press OK. A progress banner will now be displayed, running up to full
Yellow. The receiver will reboot and come back up with the first channel in the list.
NOTE Other functions in the Software Upgrade menu are for factory use only.
20