Quick Guide For Using Your Receiver; Operation; Changing Channels; Direct Access - Strong SRT 3030 User Manual

NOTE If no channels were found during the automatic channel scan, the receiver will return
to Installation guide menu. Check your cabling and connection to the cable network.
If confirmed use the advanced search options from the main menu by pressing MENU
while in the Installation guide. See chapter 7 for detailed explanations.

5.0 QUICK GUIDE FOR USING YOUR RECEIVER

We understand that you can't wait to enjoy your new HD receiver. The following quick guide will make you familiar with
the basic operation of this device. We do, however, advice you to read the full manual to get the best performance from
your HD receiver.
To turn your receiver ON or to Standby, press q on the remote control. Choose channels with pq. Alternatively, you
can also enter the channel number with the 0~9 buttons on the remote control or press OK in viewing mode to display
the channel list. The volume can be adjusted with tu.

6.0 OPERATION

This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed.
In viewing mode, several features are available to make watching TV a true pleasure. This paragraph describes these
features in short. Please also read chapter 7 to get more familiar with the menu of your new receiver with an in-depth
explanation of each menu item.

6.1 Changing channels

There are different ways to change channels with your new receiver.
„ Via direct access
„ Via the channel list
„ Via the pq buttons
„ Via the BACK button

6.1.1 Direct access

To gain direct access to a certain channel, simply enter its number with the 0~9 keys on the remote control. Channel
numbers can be up to four digits long. Entering a number with less than four digits is possible. Just wait a few seconds
and your receiver will switch to the selected channel. Or, after entering the number, press OK to speed up.

6.1.2 Channel list

Press OK in viewing mode to display the Channel List. Use pq to highlight your channel of choice and press OK once
to select the highlighted channel. The channel list is equipped with a {Find} function to make it easier to find channels.
While in the channel list, press GREEN and an alphabet banner will be displayed. Use pq tu to select the first letter
(or letters) of your channel of choice and select OK to confirm or just press EXIT. All channels beginning with the chosen
letter(s) will now be displayed. Select the channel in the filtered list.
6.1.3 Using the
pq
p will switch to a higher channel.
q will switch a lower channel.

6.1.4 Using the BACK button

Use the BACK button for switching between the previously viewed channel.

6.2 Info Banner

At any time during viewing mode you can press the INFO button to get information about the current channel as well
as the current and following programme*. Press INFO twice to view technical details about reception of the current
12
buttons