Table of Contents
Advertisement
7.3.1 FTA Only
FTA means Free-to-Air, channels that can freely be watched without the need of a subscription. For this receiver it is in
fact Free-to-Cable. A subscription to a Cable Network Operator is necessary in this case.
When selected FTA, only FTA channels will be stored, when selected {All}, then also scrambled channels will be stored,
but those can not be watched.
7.3.2 Auto Search
This is the same search method that was executed from the First Installation page.
When selecting Auto Search, a pop-up screen will be shown to confirm deleting/overwriting the (maybe) already stored
channels. Select OK to start to search, select Cancel to cancel.
Channels scan will scan VHF and UHF cable bands frequencies in the standard frequency band plan. When available,
channels found, will be put in a predetermined order, called logical channels numbering (LCN). The tuning step is
always 8MHz. Symbolrate and QAM modulation will be automatically detected. Select Start and press OK to proceed.
7.3.3 Manual Search
In this advanced search method option, you may search for one or more multiplex containing channels, if you know
the transmission parameters, such as Frequency and/or NetworkID. Sometimes these parameters are provided on
your Cable Operators website, look for Base or Home frequency or similar. Symbolrate and QAM modulation will be
automatically detected.
Keeping the NetworkID number to 00000, will just search one multiplex, but entering a valid number, it will search all
muxes and channels corresponding to that number. The tuning step is always 8MHz.
Select Start and press OK to proceed. When available, channels will also be put in a predetermined order, called logical
channels numbering (LCN).
7.3.4 Full Search
In this advanced search method you may enter the Start and End frequency of the Cable Network in use. The tuning step
is always 8MHz. Symbolrate and QAM modulation will automatically be detected. Select Start and press OK to proceed.
When available, channels will also be put in a predetermined order, called logical channels numbering (LCN).
7.4 Time menu
In this menu, general options concerning time are provided.
7.4.1 Timer Setting
In this menu item you can setup the schedule for automatic switching to the defined channels at a particular date/time.
To make a manual entry, or for editing a scheduled timer, booked by EPG, use the following options:
Delete:
Press the RED button to delete one, selected booking from the list. Press OK to confirm deleting
or EXIT to cancel.
Add:
Press GREEN to add a new (manual) booking. In the appearing screen select:
Mode
Play to only wake up the box as a reminder to view.
There is no end time for this option.
Record to record the event to a connected USB device.
Type
Once for a one time event. Daily for every day, same event, or a day mon-sun, meaning every
week the same selected day, same event.
Start date
Current date is already filled in, but can be changed with the tu and numeric buttons.
Start time
Current time is already filled in, but can be changed with the tu and numeric buttons.
Duration
Enter with the tu and numeric buttons the duration of the event.
Channel
Press OK and from the Pop-up channel list select the wanted channel with pq and OK. When
you have entered all parameters, press EXIT to confirm and store your booking.
Press the YELLOW button to edit an existing booking.
Edit:
Use the same procedure as already described above.
Press the BLUE button to delete all existing bookings in one go. Confirm with OK or cancel with
Delete All
EXIT.
17
Advertisement
Table of Contents
