2-16.Ped Balance Adjustment; 2-17.Awb Operation Confirmation; 2-18.Abb Operation Confirmation; 2-19.High Contrast Object Confirmation - Panasonic AJ-D610WBP Service Manual

2-16. PED Balance Adjustment
BOARD PRE PROCESS
TP CAM OUT
ADJUST VR103 [R PED], VR503 [B PED]
F NUMBER CLOSE
CHART -
M. EQ. Oscilloscope
SPEC. Vector Dot = Zero Point
(PED : Pedestal)
1. Connect a Vector Scope to the CAMERA OUT,
then adjust VR103 and VR503 so that the Vector
Dot is located at origin of the Vector Scope.
Note:
Vector Dot is located at origin by Color Bar.
2-17. AWB Operation Confirmation
BOARD PRE PROCESS
TP CAM OUT
ADJUST -
F NUMBER F11 + 1/2
CHART Gray Scale (2000 +/- 50 Lux)
M. EQ. Oscilloscope
SPEC. Vector Dot = Zero Point
(AWB : Automatic White Balance)
1. Connect a Waveform Monitor to the CAMERA
OUT, then adjust IRIS so that the Gray Scale level
is about 90%.
2. Set the AWB SW ON.
3. Confirm the Vector Dot is located at origin of the
Vector Scope.
Note:
Vector Dot is located at origin by Color Bar.
2-18. ABB Operation Confirmation
F NUMBER CLOSE
1. Set the ABB SW ON.
2. Connect a Vector Scope to CAMERA OUT, then
V e c to r D ot
Note:
Vector Dot is located at origin by Color Bar.
2-19. High Contrast Object
F NUMBER -
1. Shoot a 500W halogen light and set the zoom
2. Confirm that the halogen light has no smear, ghost
V e c to r D ot
3. Set the electrical shutter to 1/2000 and confirm
ELE- 10
BOARD PRE PROCESS
TP CAM OUT
ADJUST -
CHART -
M. EQ. Oscilloscope
SPEC. Vector Dot = Zero Point
(ABB : Automatic Black Balance)
confirm the Vector Dot is located at origin of the
Vector Scope.
Confirmation
BOARD PRE PROCESS
TP CAM OUT
ADJUST -
CHART -
M. EQ. Monitor TV
SPEC. No Color Smear and No Ghost
(ABB : Automatic Black Balance)
position so that the halogen light size is
approximately 1/10 of the vertical direction of the
monitor. Move the halogen spot to the four corners
of the TV monitor and confirm the followings.
and no coloring on the center of halogen spot.
same items.
V e c to r D ot