Preparation For Adjustment; Connection Of The Tool; Function Explanation(Ver. 3.2); Evr Direct Functions - Panasonic AJ-D610WBP Service Manual

<Preparation for Adjustment>

Connection of the Tool

1. Connect the cables as shown bellow with the
camera recorder and the EVR power off. The EVR
connector is located on the right side panel of
camera recorder.
AJ-D610WB
VFK1180
VFK1187
EVR
I/F BOX
VFKW1000A
VFKW1000C
DC
6V
2. Turn on the power of PC and the EVR tool first,
then turn on the power of camera recorder.
3. Set the MENU SW to SET side while pressing
[SHIFT], [+], and [-] keys together so that the
SERVICE MENU is open.
4. Press PAGE button to open SERVICE ADJ. Menu,
then change the ECU connect menu to "EVR".
After setting, set the MENU switch OFF.
5. Go to DOS mode and execute CAM_TOOL.EXE
in the VFK1162B to start EVR program.
C:\>CAM_TOOL ENTER
6. The software asks some questions and answer
for the question until opening the MAIN MENU.(If
the bar graph did not reach 100%, and did not
open the Main Menu, turn OFF and ON of I/F Box,
VFKW1000AA, then start the EVR program
again.)
SIGNAL
GENERATOR
VECTOR
SCOPE
GEN LOCK EXT SYNC
WFM
VIDEO OUT
CAM OUT
ECU
Serial (COM)
Port
Function Explanation (Ver. 3.2)
1. BACK UP (DOWN LOAD) RAM DATA.
2. RESTORE (UPLOAD) RAM DATA.
3. PREPARATION OF ADJUSTMENT.
4. START ADJUSTMENT.
5. ELECTRICAL ADJUSTMENT.
6. E.V.R. DIRECT FUNCTIONS.
7. BACK UP (DOWN LOAD) RAM DATA.<OPTION >
8. RESTORE (UPLOAD) RAM DATA
9. CREATE ADJUSTMENT ITEM <PRODUCTION>
10. START ADJUSTMENT
1,2 : These menus are not use for the electrical
adjustment section.
3~5 : Not used.
6. : Refer to next.
7,8 : These menus are not used for the electrical
adjustment section.
9. : Not used.
10. : Not used.

EVR DIRECT FUNCTIONS

1. COMMAND INPUT FUNCTION
COMMAND
DATA
ADDRESS
1. CAMERA RESET No. 1
2. CAMERA RESET No. 2
3. VF OUT
4. MONITOR OUT LEVEL
<<Page Up: INC Page Down: DEC >>
[↑] : Move To Up
[→] : Data Increment
[ESC] : Quit
1. Select "6. EVR DIRECT FUNCTIONS" in the Main
Menu of the EVR software.
2. Select "1. COMMAND INPUT FUNCTION" so that
above screen is displayed.
3. Adjustment contents are described in each
adjustment section.
4. Press ESC key to exit the Menu.
Note:
1. The changed EVR data is updated when power
is ON, therefore after adjustment power should
be turned OFF and ON.
2. The CAMERA reset No.1 and No.2 are not
used. Even if these functions are executed,
there is no effect to the camera recorder.
ELE-1
MAIN MENU
< OPTION >
<PRODUCTION>
[ EVR FUNCTION ]
: [00]
: 00
: 00
[[ ]]
[ MACRO FUNCTION ]
[F1],[A]
[F1],[B]
[F1],[C]
[F2],[0]
[↓] : Move To Down
[←] : Data Decrement
[Enter] : RAM Write