Provisioning; Setting User Options - ADC HiGain HLU-200 List 2D User Manual

150-200-124-02, Issue 2
2 Make sure the plug names for ASGN TYPE and EQPT TYPE agree.
3 Make sure the correct Common Language Equipment Identifier (CLEI) code has been entered. The correct
CLEI code for the AHDSL unit is SLILNSYAAA.
Other parameters (HARDWARE, SOFTWARE, BOOTCODE VRSN, and SERIAL NO) identify the
Litespan system; they are unrelated to the AHDSL unit.
P
ROVISIONING
All the user options in the HLU-200 List 2D can be set during provisioning.

Setting User Options

TL1 and Litecraft support standard HiGain user options with the following exceptions:
•
Two HiGain options not supported are Zero-Byte Timeslot Interchange (ZBTS) and ALRM (permanently set
to OFF and ENA, respectively). See
HLU-200 List 2D.
• Standard HiGain screens such as Span Status, Set Clock, Loopback, Performance Data, Performance History,
Alarm History, and Circuit ID are not available. These items are replaced by a set of TL1 commands and the
Litecraft Graphical User Interface (GUI) screens.
•
TL1 and Version 2.0 of Litecraft only support non-doubler applications.
In addition, TL1 and Litecraft can initiate all four loopbacks: NLOC, NREM, CLOC, and CREM.
To provision the AHDSL user options:
In the Channel Bank screen
Provisioning | Facilities | Edit Facilities. The continuous Provisioning screen appears
Figure 17 display the continuous screen as four smaller screens).
HLU-200 List 2D
Table 6 on page 12
(Figure 10 on page 17) highlight the HTU-R box and select
Figure 14. HDSL/T1 Provisioning Screen 1
February 10, 1999
for a list of the HiGain options supported by the
Managing the HLU-200
(Figure 14 through
19