Parameter Threshold - ADC HiGain HLU-200 List 2D User Manual

150-200-124-02, Issue 2
An example of setting the DSO Blocking option follows:
1 At the top of Figure 14 on page
2 Check the possible settings (Litecraft Choices) for the DS0BLK parameter in
3 To change the setting, left click current value, then right click and follow the instructions.
4 Repeat Steps 2 to 4 to provision the following options: HAIS, LP, LPBKACTC, LPBKACTR, LPBKTMO,
NIDLPBK, FMT and LINECODE.
5 Do not change any other parameters in the AHDSL Provisioning screen.
6 Click on the Apply Changes box to activate the new selections.

Parameter Threshold

The AHDSL has two parameter thresholds, Errored Seconds Threshold and Margin Threshold, described
below.
The standard 17 or 170 Errored Seconds Thresholds are determined by setting either the T1 or HDSL Errored
Seconds parameters to the value shown in
Seconds threshold to 17. Selecting a value from 17 to 170 sets the threshold to 170.
To set the T1 Errored Seconds threshold to 17 or 170 per day, set the T1 Daily thresholds using
Table 5 on page 11 and doing the following step:
HLU-200 List 2D
Figure 17. HDSL/T1 Provisioning Screen 4
19, locate the DS0BLK parameter and its corresponding setting.
Table 4 on page
February 10, 1999
Table 5 on page
10. Selecting a value from 1 to 16 sets the Errored
Managing the HLU-200
11.
21