Suzuki VITARA Series Manual page 190

Wiper and washer operation
When the ignition switch is in "ON" position
or the ignition mode is "ON", you can use
the wiper/washer lever or switch (if
equipped).
When the wipers are under heavy load
such as covered by snow, the breaker will
be activated and the wipers will stop oper-
ating to protect the wiper motor from over-
heating.
If the wiper stops during operation, do the
following methods.
1) Stop the vehicle in a safe place, and
turn the engine or the strong hybrid sys-
tem off.
2) Move the wiper lever and switch to
"OFF" position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and the wipers will be able to use.
If you cannot use the wipers after a while,
there may be another problem. Ask a
SUZUKI dealer to have the wipers
inspected.
Windshield wipers
EXAMPLE
To turn the windshield wipers on, move the
lever down to one of the three operating
positions. In "INT" position, the wipers
operate intermittently. The "INT" position is
very convenient for driving in mist or light
rain. In "LO" position, the wipers operate at
a steady low speed. In "HI" position, the
wipers operate at a steady high speed. To
turn off the wipers, move the lever back to
"OFF" position.
Move the lever up and hold it to "MIST"
position, the windshield wipers will turn on
continuously at low speed.
EXAMPLE
If the lever is equipped with "INT TIME"
61MM0A079 control, turn the control forward or back-
ward to adjust the intermittent wiper opera-
tion to the desired interval.
BEFORE DRIVING
61MM0A080
2-164