Engaging/Disengaging The Transmission-Belt Tensioner; Controls System Maintenance; Adjusting The Reel Control - Toro Greensmaster eFlex 2120 Operator's Manual

Engaging/Disengaging
the Transmission-Belt
Tensioner
The transmission belt is tensioned by a spring-loaded
idler pulley. If you must engage or disengage the
belt tension, use a 3/8-inch wrench to rotate the
engage/disengage shaft
position. Rotating the shaft 1/4 turn (90°) clockwise
disengages the idler from the belt
Note:
You must disengage the belt tension before
removing the transmission cover.
Note:
The transmission belt is properly tensioned
when the alignment marks on the transmission cover
and the engagement shaft are aligned.
Figure 43
1. E
NGAGED
(Figure 42) to the desired
(Figure 43).
2. D
ISENGAGED
Controls System
Maintenance

Adjusting the Reel Control

If the reel control does not properly engage, an
adjustment is required.
1. Turn off the machine and disconnect the battery
pack.
2. Ensure that the reel control is disengaged.
3. At the transmission bulkhead, adjust the
reel-control cable
length of 70.6 to 72.4 mm (2.78 to 2.85 inches).
g019886
1. Reel-control cable
4. At the control handle bulkhead, loosen the
reel-control cable until there is slack in the cable
(Figure 45).
39
(Figure 44), to attain a spring
Figure 44
2. Jam nuts
g017384