Belt Maintenance; Inspecting The Reel Drive Belt; Accessing The Transmission Cover Hole - Toro Greensmaster eFlex 2120 Operator's Manual

Belt Maintenance

Inspecting the Reel Drive
Belt
Service Interval: Every 1,000 hours
Make sure that the reel drive belt is properly tensioned
to ensure proper operation of the machine and
unnecessary wear.
1. Turn off the machine and disconnect the battery
pack.
2. Loosen the flange bolt that secures the belt
cover and remove the belt cover to expose the
belt (Figure 40).
Figure 40
1. Belt cover
3. Adjust the belt tension by doing the following
steps:
A. Loosen the bearing housing mounting nut
(Figure 41).
Figure 41
1. Bearing housing mounting
nut
2. Reel-drive belt
g018273
g017116
3. Compression spring
B. Using a 16 mm (5/8 inch) wrench, rotate the
bearing housing to ensure that it operates
freely.
C. Clean any debris from inside the belt
compartment and from around the
compression spring
D. Ensure that the compression spring is
applying the proper tension on the belt.
E. Tighten the bearing housing mounting nut.
F. Install the belt cover.
Accessing the
Transmission Cover Hole
Remove the rubber plug
the front of the transmission if you need to access the
reel clutch.
Important:
Do not operate the machine without
the rubber plug.
1. Engage/disengage shaft
38
(Figure 41).
(Figure 42) from the hole in
Figure 42
2. Rubber hole plug
g017387