Changing The Engine Coolant; Checking The Radiator Hoses; Belt Maintenance; Checking The Drive Belt Tension - Toro Maxi Sneaker 370 Operator's Manual

Checking the Engine Coolant Level (continued)
1. Remove the radiator
caps.
2. Check the coolant level in the radiator.
Note:
neck and the expansion tank to the full mark.
3. If the coolant is low, add the mixture to the full
mark.
4. Install the radiator cap and expansion tank
cap.

Changing the Engine Coolant

1. Remove the radiator
caps and drain plug
2. After the fluid has drained, install the drain
plug.
3. Add the coolant mixture at the cap to keep the
level at the top of the filler neck and the
expansion tank.
Note:
neck and the expansion tank to the full mark.
4. Install the cap.

Checking the Radiator Hoses

Check the radiator hoses for leaks, abnormal swelling, or other signs of deterioration. Check
for leaks or corrosion at the water pump and fittings.

Belt Maintenance

Checking the Drive Belt Tension

The belt is properly tensioned when it moves about 7–10 mm (1/4–3/8 inch) when you push
it at the long span.
3455-524A
and expansion tank
Fill the radiator to the top of the filler
and expansion tank
.
Fill the radiator to the top of the filler
G428621
G416157
Page 7–14 Maintenance: Cooling System Maintenance