Incoming Inspection; Recording The Device Serial Numbers; Clarifying The Terminology Of A Connector Interface - Agilent Technologies 85032F User's And Service Manual

Type-n 50 calibration kit

Table of Contents

General Information

Incoming Inspection

Refer to Figure 6-1 on page 6-2 to verify a complete shipment.

Check for damage. The foam-lined storage case provides protection during shipping. If the

case or any device appears damaged, or if the shipment is incomplete, contact Agilent

Technologies. See "Contacting Agilent" on page 5-4. Agilent will arrange for repair or

replacement of incomplete or damaged shipments without waiting for a settlement from

the transportation company. See "Returning a Kit or Device to Agilent" on page 5-3.

In addition to the kit serial number, the devices in this kit are individually serialized

(serial numbers are labeled onto the body of each device). For your convenience, the

following table is provided for you to record these serial numbers. Recording the serial

numbers will prevent you from confusing the devices with similar devices.

Table 1-1

Kit and Device Serial Number Record

Device

Calibration kit

Broadband load –m–

Broadband load –f–

Open –m–

Open –f–

Short –m–

Short –f–

In this document and in the prompts of the PNA calibration wizard, the gender of cable

connectors and adapters is referred to in terms of the center conductor. For example, a

connector or device designated as 1.85 mm –f– has a 1.85 mm female center conductor.

8510-series, 872x, and 875x ONLY: In contrast, during a measurement calibration, the

network analyzer softkey menus label a 1.85 mm calibration device with reference to the

sex of the analyzer's test port connector—not the calibration device connector. For

example, the label SHORT(F) refers to the short that is to be connected to the female test

1-4

Serial Number

_______________________________

85032F

Table of Contents