KTM 950 ADVENTURE 2003 Manual page 96

2
3
5
6
– Position both connecting rods
Loctite 243 and mount.
1
NOTE: bend the fuel connections according to the recesses in the
connecting rods before mounting the connecting rods.
1
– Mount the throttle linkage arm
drawing and secure with the pins.
NOTE: slide the curved plastic shims
– Screw on the throttle sensor and cable for the idle setting.
2
Adjusting the float level
NOTE: it is not necessary to separate the two carburetors to adjust the
float level.
– Remove the float chamber.
4
– Turn the carburetor aside until the float
needle valve.
– Place the setting gauge 600.29.016.000
highest part of the float. The setting gauge should not press against
the float but there should not be a gap between the setting gauge
and the float. If necessary, bend the arm on the float and check
again.
– Mount the float chamber.
Adjusting the idle mixture control screw
NOTE: the idle mixture control screw can only be adjusted when the
carburetor is dismounted.
– Screw the mixture control screws in to the limit.
– Screw out the mixture control screws 2 1/4 turns (see Technical
Specifications).
1
, coat the thread of the screws with
2
3
See page 8-11 to adjust/check the throttle sensor.
See page 12-9 to adjust the idle speed.
See page 12-9 to synchronize the carburetor.
See page 8-11 to adjust the throttle cable.
8-10
with shims as shown in the
on the bolts first.
4
presses lightly against the
5
on the carburetor at the