Edit From A Camcorder - JVC DR-MX1SEF Instructions Manual

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
Player
B If the camcorder has an S-VIDEO output connector (HDD
& DVD deck only):
To
To [AUDIO] input
[S-VIDEO]
input
S-video cable
(not supplied)
Player
Recorder
AUDIO/VIDEO OUT
Recorder
Audio cable
(not supplied)
S-VIDEO OUT
AUDIO OUT
Slide the TV/CABLE/DBS/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's [VIDEO/AUDIO ((MONO) L/R)] input connectors on the front
panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's [AUDIO] and [S-VIDEO] input connectors
on the front panel.
2
Press VHS/HDD/DVD SELECT on the unit repeatedly to select
the recording deck.
3
Press CH +/– to select "F-1".
Set "FRONT AUX F-1" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
EDITING
pg. 83)
75
EN