Edit From A Camcorder - JVC DR-MV4SUJ Instructions Manual

EDITING
40
EN

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
STANDBY/ON
S-VIDEO VIDEO AUDIO
DVD F−1
(MONO)
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
Player
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
STANDBY/ON
S-VIDEO VIDEO AUDIO
F−1
DVD
(MONO)
To
To [AUDIO] input
[S-VIDEO]
input
S-video cable
(not supplied)
Player
VHS DVD
VHS/DVD ONE-TOUCH EXPERT DUB
VHS DUBBING DVD
Recorder
AUDIO/VIDEO OUT
VHS DVD
VHS/DVD ONE-TOUCH EXPERT DUB
VHS DUBBING
Audio cable
(not supplied)
S-VIDEO OUT
AUDIO OUT
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's [VIDEO/AUDIO ((MONO) L/R)] input connectors on the front
panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's [AUDIO] and [S-VIDEO] input connectors
on the front panel.
REC 2
CH
Press VHS/DVD on the unit repeatedly to select the recording
deck.
3
Press CH +/– to select "F-1".
Set "FRONT AUX F-1" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
REC
CH
DVD
Recorder
pg. 71)