Edit From A Camcorder - JVC DR-MV1 Instructions Manual

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
AUDIO/VIDEO input
F-1
Audio/video cable
(not supplied)
AUDIO/VIDEO OUT
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
S-VIDEO input
AUDIO input
F-1
Audio cable (not supplied)
S-Video cable
(not supplied)
Player
AUDIO OUT
S-VIDEO OUT
Player
Slide the TV/CABLE/DBS/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's AUDIO/VIDEO input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B If the camcorder has an S-VIDEO output connector: (DVD deck
only)
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's AUDIO and S-VIDEO input connectors on
the front panel.
2
Press VCR/DVD repeatedly to select the recording deck.
3
Press CH +/– to select "F-1".
Recorder
For DVD deck
Set "FRONT AUX F-1" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
Recorder
EDITING
pg. 74)
67
EN