Table of Contents
Advertisement
66
EN
Edit From A
Camcorder
Recorder
AUDIO input
VIDEO
input
Audio/video cable
To Audio/VIDEO
Output
connectors
Camcorder
To Edit
Player
To REMOTE
PAUSE
connector
(not supplied)
Mini-plug cable
(not provided)
(JVC camcorder
only)
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/VCR/DVD switch to the right.
A
Make connections.
Connect the camcorder's AUDIO OUT and VIDEO OUT
connectors to the unit's front panel AUDIO and VIDEO
input connectors.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
● When a Master Edit Control - equipped JVC camcorder is used, the
camcorder is capable of controlling the unit. Refer to the camcorder's
instruction manual for operating procedure.
B
Select the VCR deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Set the unit's input mode.
Press AUX (number key "0") and/or CH to select "F-1".
D
Set the edit mode.
See "PICTURE CONTROL" on page 73.
E
Engage the Record Pause mode.
Use PLAY (4), REW (3), or FF (5) to locate the
point where you start recording, then press and hold
PAUSE (9) and press REC (7) to engage the Record
Pause mode.
F
Start the camcorder.
Engage the Play mode of the camcorder.
G
Start the unit.
Press PLAY (4) to engage the Record mode of the unit.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select "EDIT" to dub tapes in step D, be sure to select
"NORM" after you finish dubbing the tapes.
EDITING (VCR DECK)
Advertisement
Table of Contents
