Editing (Vcr Deck); Edit From A Camcorder - JVC HR-XVS44U Instructions Manual

68
EN
Edit From A
Camcorder
A
If the camcorder has no S-VIDEO output connector:
Recorder
AUDIO input
VIDEO
input
Audio cable (not provided)
Video cable (not provided)
VIDEO OUT
AUDIO OUT
Camcorder
Player
B
If the camcorder has an S-VIDEO output connector:
S-VIDEO input
AUDIO input
Audio cable (not provided)
S-Video cable (provided)
S-VIDEO OUT
AUDIO OUT
Camcorder
Player
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/VCR/DVD switch to the right.
A
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and VIDEO
OUT connectors to the unit's front panel AUDIO and
VIDEO input connectors.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and
S-VIDEO OUT connectors to the unit's front panel
AUDIO and S-VIDEO input connectors.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Press AUX (number key "0") and/or CH to select "F-1".
When using S VIDEO connector, set "FRONT AUX INPUT" to
"S-VIDEO". (
When using VIDEO connector, set "FRONT AUX INPUT" to
"VIDEO". (
D
See "PICTURE CONTROL" on page 76.
Recorder
E
Use PLAY (4), REW (3), or FF (5) to locate the
point where you start recording, then press and hold
PAUSE (9) and press REC (7) to engage the Record Pause
mode.
F
Engage the Play mode of the camcorder.
G
Press PLAY (4) to engage the Record mode of the unit.
NOTES:
Dubbing is also possible using the rear panel connectors.
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "VIDEO CALIBRATION" is
set to "OFF") after you finish dubbing the tapes.

EDITING (VCR DECK)

Make connections.
Select the VCR deck.
Set the unit's input mode.
pg. 79)
pg. 79)
Set the edit mode.
Engage the Record Pause mode.
Start the camcorder.
Start the unit.