In Case Of Difficulty; Error Displays - Clarion DVS9755z Installation Manual

8. IN CASE OF DIFFICULTY

Problem
Power does not
turn on.
(No sound is
produced.)
Nothing happens
when buttons are
pressed.
Disc cannot be
loaded.
The disc is
ejected as soon
as it is inserted.
Sound skips or is
noisy.
Sound is bad
directly after
power is turned
on.

9. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
A DVD/CD is caught inside the DVD
ERROR 2
deck and is not ejected.
ERROR 3 A DVD/CD cannot be played due to
scratches, etc.
ERROR 6 A DVD/CD is loaded upside-down inside
the DVD deck and does not play.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
26
DVS9755z
Cause
Fuse is blown.
Incorrect wiring.
The microprocessor has
malfunctioned due to noise,
etc.
The microprocessor has
malfunctioned due to noise,
etc.
Another disc is already
loaded.
The disc has been inserted
upside down.
Disc is dirty.
Disc is heavily scratched or
warped.
Water droplets may form on
the internal lens when the
car is parked in a humid
place.
Cause
Measure
Replace with a fuse 3A of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Press the reset button with a thin rod.
Reset button
Press the reset button with a thin rod.
Eject the disc before loading the new one.
Insert the disc with the label side up.
Clean the disc with a soft cloth.
Replace with a disc with no scratches.
Let dry for about 1 hour with the power on.
This is a failure of DVD deck's mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
Measure