Setting Acoustic Features (Adjust Mode) - Clarion DVS9755z Installation Manual

Setting acoustic features (ADJUST MODE)

In this chapter, the control unit buttons are used.
Selecting adjust mode settings
Adjust the settings to suit your sound system.
1. Press the [ADJUST] button to enter the AD-
JUST MODE.
2. Press the [ ] or [
item to set.
Each time the [ ] or [
pressed, the indications change as shown
below.
Adjust automatic sound format identification
(FORMAT)
Set speaker to on or off
(SP-SEL)
Set speaker filter frequency
(FILTER)
Adjust speaker output level
(SP-GAIN)
Set speaker delay time
(DELAY)
Set Dolby digital
(Dolby D)
Set parametric equalizer
(P.EQ)
Press the [ADJUST] button to return to the
original mode.
18
DVS9755z
] [DISP] button to select
] [DISP] button is
Control unit button operations
A flow chart is shown on the next page.
*1. The display shows the settings made in the
Section, "Changing display settings" (11
page).
*2. When an is displayed at the end of a
setting, press the [ENT] button to enter the
adjust mode.
*3. When the illustration is shown, press
the indicated button (the [ENT] button in this
example).
*4. When [ ] is displayed to the left of the
adjusted value, press the [
button to switch the setting.
*5. When the [VOL] buttons are not used within
1 sec, the adjustment value display is
switched.
*6. When [ ] is displayed to the left of the ad-
justed value, press the [
ton to switch the adjustment value.
*7. The next item is displayed.
] or [ ] [DISP]
] or [ ] [VOL] but-