Thank you for purchasing this Clarion product. ∗ Please read this owner’s manual in its entirety before operating this equipment. ∗ After reading this manual, be sure to keep it in a handy place (e.g., glove compartment). ∗ Check the contents of the enclosed warranty card and keep it carefully with this manual.
5. DCP The control panel can be detached to prevent Storing the DCP in the DCP Case theft. When detaching the control panel, store it Hold the DCP, in the orientation as shown in the in the DCP (DETACHABLE CONTROL PANEL) figure below, and put it into the supplied DCP case to prevent scratches.
6. REMOTE CONTROL Operating range: 30˚ in all directions Signal transmitter Remote control unit [ FUNC ] [ ISR ] [ MUTE ] [ SCN ] [ RPT ] Inserting the Batteries 1. Turn the remote control unit over, then slide the rear cover in the direction of the arrow.
7. OPERATIONS Note:Be sure to read this chapter referring to the front diagrams of Basic Operations chapter “3. CONTROLS” on page 5 (unfold). Adjusting the volume CAUTION Turning the [ROTARY] knob clockwise Be sure to lower the volume before increases the volume; turning it switching off the unit power or the ignition counterclockwise decreases the volume.
Radio Operations Basic Operations Adjusting the Z-Enhancer Plus FM reception 1. Press the [Z+] button and select the Z- For enhanced FM performance the Enhancer Plus mode to adjust. tuner includes signal actuated stereo control, Enhanced Multi AGC, Impulse noise reduction 2.
Message up to 30 characters long can be stored in memory and displayed for any mode. * The factory default setting is “WELCOME TO CLARION”. 1. Press and hold the [TITLE] button for 1 second or longer to switch to the adjustment selection display.
Page 10
Operations Common to Each Mode 5. Press the [DISP] button to select a character. Adjusting the display contrast Each time you press the [DISP] button, the You can adjust the display contrast to match the character changes in the following orders: angle of installation of the unit.
8. OPERATIONS OF ACCESSORIES CD/MD Changer Operations CD/MD changer functions Notes: • If the CD playing is not a CD-text CD or no user When an optional CD/MD changer is connected title has been input, “NO TITLE” appears in the through the CeNET cable, this unit controls all display.
TV Operations TV tuner functions Manual tuning When an optional TV tuner is connected through There are 2 ways available: Quick tuning and the CeNET cable, this unit controls all TV tuner step tuning. functions. To watch TV requires a TV tuner and When you are in the step tuning mode, the monitor.
9. IN CASE OF DIFFICULTY Problem Cause Power does not turn Fuse is blown. Replace with a fuse of the same amperage. If the fuse blows again, consult your store of (No sound is pro- purchase. duced.) Incorrect wiring. Consult your store of purchase. No sound output Power antenna lead is shor- 1.
11. SPECIFICATIONS FM Tuner Audio Frequency Range: Maximum Power Output: 208 W (52 W ✕ 4 ch) 87.0 MHz to 108 MHz Usable Sensitivity: Continuous Average Power Output: 17 W ✕ 4, into 4 Ω, 20 Hz to 20 kHz, 1%THD 9 dBf 50dB Quieting Sensitivity: Bass Control Action (60 Hz):...