Toro Reelmaster 3100-D Series Installation Instructions Manual page 2

Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Note: Determine the left and right sides of the cutting unit
from behind the cutting unit.
Important: The Rear Roller Brush Kit is only to be
used when cutting in the height of cut range of 6 to 25
mm (1/4 to 1 inch). Use the High Height of Cut Brush,
Part 115-0838 (for 27 inch cutting units) and 115-0849
(for 32 inch cutting units) when cutting above 2.5 to 5.1
cm (1 to 2 inches). Refer to Installing the High Height
of Cut Brush.
Description
No parts required
No parts required
No parts required
No parts required
Roller-brush housing
Allen-head bolt, 3/8 x 1 inch
Roller-brush assembly
Shoulder bolt
Belt cover/plate assembly
Bolt, 5/16 x 5/8 inch
Spacer
Drive pulley
Flange-head bolt, 3/8 x 2 inches
Belt
Shim washer (as required)
High height of cut brush (optional)
Qty.
–
–
–
–
1
2
1
1
1
2
1
1
1
1
1
–
Qty.
1 Read before installing and operating.
1 Use to look up replacement parts.
Rear Roller Brush Kit Model 03186 may be used on the
following:
•
Reelmaster 3100 Cutting Unit Models 03180, 03181, and
03183 with the 27-inch Lift Arm Kit, Model 03172
•
Reelmaster 7000 Cutting Unit Models 03710 and 03711
Rear Roller Brush Kit Model 03187 may be used on the
following:
•
Reelmaster 3100 Cutting Unit Model 03182 with the
32-inch Lift Arm Kit, Model 03173
•
Reelmaster 7000 Cutting Unit Model 03712
2
Use
Gather the appropriate tools.
Determine the position of the roller
brushes and reel motors.
Reposition the idler pulley assembly.
Remove the brush cover drain plug.
Install the roller brush.
Install the high height-of-cut brush.
Use