Adjusting The Cutting Unit; Installing The Grass Basket; Installing The High-Altitude Kit (Optional) - Toro 04054 Greensmaster 800 Operator's Manual

1. Locking clip
3. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is secured
in the groove on the axle shaft.
4. Repeat the procedure on the opposite side of the
machine.
5. Inflate the tires to 574 to 718 Pa (12 to 15 psi.).
5

Adjusting the Cutting Unit

No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
•
Leveling the Rear Drum to the Reel (page
•
Adjusting the Bedknife to the Reel (page
•
Adjusting the Height of Cut (page
•
Adjusting the Grass Shield Height (page
•
Adjusting the Cut-Off Bar (page
Refer to the Cutting Unit Maintenance section in Maintenance
for instructions on performing these procedures.
G017591
Figure 8
31).
32).
33).
34).
34).
6

Installing the Grass Basket

Parts needed for this procedure:
1 Grass basket
Procedure
Grasp the basket by the top lip and slide it onto the basket
mounting rods (Figure
1. Grass basket
Note: Model 04056 only—When cutting in higher
heights-of-cut, the basket may be lowered by removing each
basket mounting rod and installing each on the opposite side
of the machine.
7
Installing the High-Altitude Kit
(Optional)
Parts needed for this procedure:
High-altitude kit, part number 117-0073 (acquire
1
separately as needed)
Procedure
If you will be using the machine at altitudes above 1500
m (5000 ft), obtain and install the High-Altitude Kit, part
number 117-0073.
13
9).
Figure 9
2. Basket mounting rod