Shop-Vac SM12 Series User Manual page 9

4. Attach the extension wands to the accessory end of the hose. Twist the wands
slightly at each connection to secure them into place.
5. Attach one of the cleaning accessories (depending on your cleaning
requirements) onto the extension wands. Twist the accessory slightly to tighten the connection. NOTE:
Many more useful tools are available at your local dealer or the Shop-Vac
6. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
AIRFLOW INDICATOR (PERFORMANCE GAUGE)
(Not standard with all models)
The performance of the vacuum is largely dependent on the air flowing through the unit. The airflow
indicator can help you monitor the airflow. NOTE: It is important to check your filters periodically even if
the ai rflow i ndi cator does not regi ster that there i s a probl em. If your fil ter i s not i nstal l ed properl y,
mi ssi ng the fil ter retai ner or has a hol e, the ai rflow wi l l not reduce and regi ster on the i ndi cator.
These i ssues coul d damage the vacuum motor or cause dust to di scharge from the exhaust. To use
the indictor, make sure it is installed on the blower port cover. Remove any accessories from the hose and
position the hose end so it is open to the air. Turn the unit on and look to see where the bar on the filter
indicator is positioned. If the end of the bar is in the green, continue your cleaning operation. If it is in the
yellow, consider reviewing the chart in this section to improve the vacuum's performance. If it is in the red,
turn the unit off and review the chart in this section. It is normal for the bar to move during the cleaning
process due to the accessory or hose being moved across a surface.
POTENTIAL CAUSE
Dirty or clogged filter
Full tank
Automatic suction shut off
float is engaged
Air Leak
Obstruction in hose
Hose end isn't open to the air
Filter indicator not attached to
blower port cover
Vacuum motor not running
SOLUTION
1. Clean or replace filter.
1. Empty tank
1. Make sure vac is in the upright position.
2. Empty the tank.
3. Remove filter from lid cage and make sure
float is located at the bottom of the cage.
1. If vac has a tank drain, make sure the
drain cap is installed.
2. Tighten the hose connection. If this doesn't
improve airflow, remove hose from inlet and
retest. If the airflow is improved, replace the
hose.
1. Remove obstruction or replace hose.
1. Position hose end away from floor, wall, etc.
and retest.
1. Install indicator onto blower port cover.
1. Make sure the power cord is plugged into
the outlet and there is power to the outlet. If
the motor still won't run, contact Shop-Vac
customer service.
®
website.
®
PAGE 9