Shop-Vac SM12 Series User Manual page 6

4. Insert casters into bottom of rear caster dolly by placing stem of caster into holes
provided. Apply pressure and twisting motion until casters snap into place.
5. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A and secure
with screw provided.
6. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B and secure with screw provided.
7. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
PLASTIC TANK WITH REAR BASKET
You will ind two casters, two caster feet, two rear wheels, one axle, two cap nuts, one basket
and four screws with your vacuum. Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that bottom is facing up.
2. Stand axle upright on hard surface and hammer on one cap nut.
3. Place one wheel on axle and slide down to cap nut. Be sure flat side of wheel
hub is facing outward.
4. Slide axle through holes provided in basket.
5. Slide remaining wheel onto axle. Make sure wheels are positioned correctly.
Hammer on second cap nut.
PAGE 6
ASSEMBLY (CONT'D.)
Screw
Caster
Foot
Screw
Caster
Caster
Caster
Foot
Foot