Table of Contents
Advertisement
The Nozzle-Position Gauge
The nozzle-position gauge
behind the turbine housing, above the fuel tank.
Note:
The decal on the nozzle-position gauge
indicates the position of the nozzle relative to the
ground.
Figure 12
Some parts hidden for clarity.
1. Red pointer
2. Nozzle-position gauge and
decal
There is a red pointer and a green pointer
attached to the blower nozzle.
Nozzle Alignment
•
When the red pointer is visible in the nozzle
position gauge, the blower nozzle is aligned to
blow to the right of the machine.
•
When the green pointer is visible in the nozzle
position gauge, the blower nozzle is aligned to
blow to the left of the machine.
Nozzle Angle
The pointer and gauge indicate the blower nozzle
angle as follows:
(Figure
12) is located
3. Green pointer (shown
in the window of the
nozzle-position gauge
window—left aligned
blower nozzle)
(Figure
•
When the pointer is in the same colored region on
the decal, that indicates that the chute opening is
positioned more parallel to the ground.
•
When a pointer tab is in the different colored
region on the decal, that indicates that the chute
opening is positioned more toward the ground.
Operating Tips
•
Practice operating the blower. Blow the same
direction that the wind blows to prevent material
from blowing back into the cleared area.
•
When blowing debris from a job site, run the
engine at full throttle.
•
Adjust the blower nozzle position so that the
airstream blows under the debris.
•
Use caution when blowing around newly planted
sod; the airstream could disrupt the grass.
g375233
12)
17
Advertisement
Table of Contents
